Can I reset my MetroLinq to factory defaults from via SSH?

Can I reset my MetroLinq to factory defaults from via SSH?

Yes, you can reset your MetroLinq to factory defaults via SSH by:

1. SSH into the device with your administrator user name and password (default pair is "root", "admin123" respectively).
2. Use the command "reset_to_defaults.sh -y" to reset your device.

    • Related Articles

    • Can I reset my MetroLinq to factory defaults from the Web GUI?

      Yes, you can reset your MetroLinq to factory default settings from the Web GUI. To reset your device from the Web GUI: 1. Navigate to "System" 2. Select "Maintenance" 3. Click on the "Reset" button

    • Is there a reset  button on my MetroLinq?

      Yes, It is possible to reboot or reset the MetroLinq by inserting a pin in the pin hole labeled “Reset” on the connector panel of MetroLinq for 2 seconds to reboot the MetroLinq or 12 seconds to reset the MetroLinq to the factory defaults. The status ...

    • MetroLinq 60 (ML-60 first generation) Firmware

      Supported Models The firmware on this page applies to the following MetroLinq models ONLY: ML-60-35 ML-60-19 ML-60-30-18 Must-Read Upgrade Notes: 1.1.8 and later FW versions are not compatible with MetroLinq serial serial numbers starting with AF ...

    • MetroLinq Alignment Scope

      Introduction The MetroLinq™ Alignment Scope speeds up the aiming process, which is critical for deployment of 60 GHz links. Other helpful uses include verifying optical line of sight for the link, ensuring local mount placement viability, and ...

    • MetroLinq Installation and Alignment Tutorial

      This tutorial provides a guide to installation and alignment of MetroLinq products. Mounting The mounting structure to which the MetroLinq mounting bracket is attached should be plumb (not crooked) and stable to avoid polarization mismatch. Choosing ...