Can I use any ML device as a client in a PTMP setup?

Can I use any ML device as a client in a PTMP setup?

Typically the client devices for PTMP deployments are the higher gain models such as ML2.5-60-35, ML2.5-60-19, ML-60-35 and ML-60-19, but the beamforming models (such as the ML2.5-60-BF-18 and ML60-LW) can also be connected as clients at shorter distances. 

    • Related Articles

    • MetroLinq 60 (ML-60 first generation) Firmware

      Supported Models The firmware on this page applies to the following MetroLinq models ONLY: ML-60-35 ML-60-19 ML-60-30-18 Must-Read Upgrade Notes: 1.1.8 and later FW versions are not compatible with MetroLinq serial serial numbers starting with AF ...

    • MetroLinq 60 One (ML1) & MetroLinq 60 LW (ML-60-LW) Firmware

      Supported Models The firmware on this page applies to the following MetroLinq models:   ML-60-LW-XX ML1-60-XX Version 2.4.2 May 11, 2020 Downloads ML 60 LW -2.4.2-4531 ML 60 One - 2.4.2-4531 Release Notes Fix 2.4Ghz can not be disabled issue Fix TX ...

    • ML-60-LW info and links

      Introduction IgniteNet’s MetroLinq 60 LW (lightweight) changes the economics of low-cost 60GHz PTP and PTMP connections. With a 60GHz range of up to 150m (0.1mi) as well as built-in 5GHz failover, it can provide reliable high throughput in the ...

    • What type of encryption does MetroLinq use for wireless links?

      MetroLinq devices use AES-128 for link encryption. 

    • Can I use the second GE port of the ML-60-XX for traffic purposes?

      The second Ethernet port is bridged to the 60 GHz interface, but not the other Ethernet port. You can therefore pass traffic over the link, but you will not be able to see devices connected to the Eth0.