What are the channel bandwidths supported by the MetroLinq's 60 GHz and 5 GHz radios?

• Related Articles

• What separation distance I have to give to my MetroLinq radios installed on the same pole?

  In General, there is no hard requirement for co-location of MetroLinq radios on the same pole, but care should be taken to allow the mount position to be moved up to one meter in any direction (up or down is typically the easiest) in case multipath ...

• MetroLinq 10G Omni Firmware

  Supported Models The firmware on this page applies to the following MetroLinq models:  ML-60-10G-360-XX Version 2.4.2 May 11, 2020 Downloads 2.4.2-4179 Release Notes NOTE: Upgrade client units first Fix 2.4Ghz can not be disabled issue Fix TX power ...

• MetroLinq 2.5G 60 Firmware

  Supported Models The firmware on this page applies to the following MetroLinq models:   ML2.5-60-35-XX ML2.5-60-19-XX ML2.5-60-BF-18-XX  Upgrade Alerts Please read the following message carefully before upgrading! Devices running firmware versions ...

• Can my MetroLinq form a PTP link with 60 GHz radios from other brands? What about connecting to the 5GHz back up radio?

  For 60GHz, MetroLinq devices can only form 60 GHz links with other MetroLinq devices. For the 5GHz back up radio, the first SSID only allows IgniteNet radios to connect. If you add a second 5GHz virtual SSID, then any standard 802.11 based radios can ...

• What are the 60 GHz antenna beam-widths for the MetroLinq product line?

  The antenna beam-widths for the 60 GHz radios are: 35cm models (ML1-60-35 and ML2.5-60-35) = 1 degree Horizontal and 1 degree Vertical. dB gain is 42dBi  19cm models (ML1-60-19 and ML2.5-60-19) = 3 degrees Horizontal and 3 degrees Vertical. dB gain ...