Does the MetroLinq have any failover or redundancy modes?
Yes. MetroLinq devices have a 5 GHz back-up radio that can be used for redundancy and/or failover in case of 60 GHz link failure.
Related Articles
MetroLinq 10G Omni Firmware
Supported Models The firmware on this page applies to the following MetroLinq models: ML-60-10G-360-XX Version 2.4.2 May 11, 2020 Downloads 2.4.2-4179 Release Notes NOTE: Upgrade client units first Fix 2.4Ghz can not be disabled issue Fix TX power ...
MetroLinq 2.5G 60 Firmware
Supported Models The firmware on this page applies to the following MetroLinq models: ML2.5-60-35-XX ML2.5-60-19-XX ML2.5-60-BF-18-XX Upgrade Alerts Please read the following message carefully before upgrading! Devices running firmware versions ...
MetroLinq 60-30-18 Info and Links
Introduction The MetroLinq 60 Sector (ML-60-30-18) enables high performance, interference-free connections by combining 60 GHz and 5 GHz technology in a small form factor, and can be deployed in PTP links, as PTMP access points (APs) or as PTMP ...
MetroLinq 60-19 Info and Links
Introduction The MetroLinq 60-19 (ML-60-19) enables high performance, interference-free connections by combining 60 GHz and 5 GHz technology in a small, 19cm form factor, and can be deployed in PTP links or as PTMP clients. 60 GHz Performance The ...
MetroLinq 60-35 Info and Links
Introduction The MetroLinq 60-35 (ML-60-35) enables high performance, interference-free connections by combining 60 GHz and 5 GHz technology in a 35cm form factor, and can be deployed in PTP links or as PTMP clients. 60 GHz Performance The MetroLinq ...