What is the maximum cable distance between the PoE injector and the MetroLinq?
The maximum recommended distance is 100 m using Cat 5e.
Related Articles
What is the maximum MTU size for MetroLinq?
The maximum MTU size supported by the 60 GHz radio is 7912.
MetroLinq 2.5G 60-35 Info and Links
Introduction MetroLinq 2.5G 60 series point-to-point devices support an extreme capacity of 2.5 Gbps. Its new generation RF powered by a quad core CPU supports higher modulation allowing delivery of more than two times higher capacity (up to 4.6 Gbps ...
MetroLinq LR Precision Bracket
Introduction The MetroLinq™ long range bracket is a precision tool designed to give ultimate accuracy and stability for the links that maximize the distance of the MetroLinq™ radio. With the offset design you can install maximize the number of units ...
MetroLinq 10G Omni Firmware
Supported Models The firmware on this page applies to the following MetroLinq models: ML-60-10G-360-XX Version 2.4.2 May 11, 2020 Downloads 2.4.2-4179 Release Notes NOTE: Upgrade client units first Fix 2.4Ghz can not be disabled issue Fix TX power ...
What separation distance I have to give to my MetroLinq radios installed on the same pole?
In General, there is no hard requirement for co-location of MetroLinq radios on the same pole, but care should be taken to allow the mount position to be moved up to one meter in any direction (up or down is typically the easiest) in case multipath ...