Is there a reset  button on my MetroLinq?

Is there a reset  button on my MetroLinq?

Yes, It is possible to reboot or reset the MetroLinq by inserting a pin in the pin hole labeled “Reset” on the connector panel of MetroLinq for 2 seconds to reboot the MetroLinq or
12 seconds to reset the MetroLinq to the factory defaults. The status LED of the radio will change color. Wait approximately five minutes for the unit to be reset to factory defaults.

    • Related Articles

    • Can I reset my MetroLinq to factory defaults from the Web GUI?

      Yes, you can reset your MetroLinq to factory default settings from the Web GUI. To reset your device from the Web GUI: 1. Navigate to "System" 2. Select "Maintenance" 3. Click on the "Reset" button

    • Can I reset my MetroLinq to factory defaults from via SSH?

      Yes, you can reset your MetroLinq to factory defaults via SSH by: 1. SSH into the device with your administrator user name and password (default pair is "root", "admin123" respectively). 2. Use the command "reset_to_defaults.sh -y" to reset your ...

    • MetroLinq 60 (ML-60 first generation) Firmware

      Supported Models The firmware on this page applies to the following MetroLinq models ONLY: ML-60-35 ML-60-19 ML-60-30-18 Must-Read Upgrade Notes: 1.1.8 and later FW versions are not compatible with MetroLinq serial serial numbers starting with AF ...

    • MetroLinq 60 One (ML1) & MetroLinq 60 LW (ML-60-LW) Firmware

      Supported Models The firmware on this page applies to the following MetroLinq models:   ML-60-LW-XX ML1-60-XX Version 2.4.2 May 11, 2020 Downloads ML 60 LW -2.4.2-4531 ML 60 One - 2.4.2-4531 Release Notes Fix 2.4Ghz can not be disabled issue Fix TX ...

    • MetroLinq 5 LW Firmware

      Supported Models The firmware on this page applies to the following MetroLinq models:   ML-60-5-LW-XX Version 2.3.5 June 27, 2019 Downloads 2.3.5-4023 Release Notes NOTE: Upgrade client units first Fixed an issue where a wireless link isn't possible ...